FOXTEAM UAV CLAN

a Virtual Robotix Network Team

VR micro Brain 5 firmware is ready!!! Now is possible to upload the firmware and different frame configuration by Mission Planner : Multicopter , Plane or Rover

Dear Friends,

02 / 06 / 2014 

After one month of work the stable firmware for VRBrain micro is ready . We fly a lot in manual and automatic , we are preparing a video and specific blog post about VRX250 the drone platform using for doing test on VRBrain micro  5 all work fine and we are happy to have a good revision of code for user that join us in pre order campaign . We start to deliver first batch of boards in 2 weeks . The good news is that now is possible to upload the firmware to VR Brain micro 5 using standard Mission Planner application. Thanks to Michael and all VR Lab team for doing a good Job around this task.

09 / 05 / 2014

today we finish to test first prototype of micro brain , this is the video of first power on , all work fine , we check all onboard sensor : IMU , BAROMETER  . Check eeprom for parameter storage and SD card. Serial port , and usb interface . All work fine :) Check also new bootloader and our mission planner fork with VRBrain support all work perfect . Diego our Electronic Designer doing a great work no error until now :)

Finish the test of all subsystem : Magnetomer , GPS , RC IN PPMSUM and RC OUT and all work fine . See the video .

These are the specification : 

CPU STM32F4 VR OS based on NuttX kernel 7.1 

1 EEPROM or FRAM device for parameter storage. 

IMU MPU6000 SPI.

MSIC Barometer 10 cm resolution.  

8 PPM Radio RC Input .

8 PWM ESC - SERVO Output.

1 SBUS Radio Input compatible with Futaba SBUS and Spektrum ,too

1 SBUS Servo Output.

SD Card Reader until 64 Gbyte.

1 RGB LED 

2 LED Output 

1 Buzzer Output 

On board telemetry module availabe at 433 / 868 mhz. (option) 

connector for external 3DR/VR GPS + MAGNETOMETER

dimension : 3.2 x 3.2 .

weight : 10 gr

Price is 99 euro the board pre order is open the mass production start in 1 week when finish the test of first production batch .

more info about status of the product  on the store: http://www.virtualrobotix.it/index.php/en/shop/autopilot/vrbrainmic...

APM Copter , Plane , Rover Firmware available and fully tested by our devteam.

official blog post : http://www.virtualrobotix.com/profiles/blogs/vr-micro-brain-5-1-is-...

for more info send a mail to info@virtualrobotix.com

Best

Roberto 

Views: 71

Comment

You need to be a member of FOXTEAM UAV CLAN to add comments!

Join FOXTEAM UAV CLAN

Comment by Stuart Brookes on June 8, 2014 at 7:36pm

Hi Roberto,

Is it possible to set the lipo voltage input to read the output from a current sensor and have arducopter to count the amp hours as with apm?

Thanks,

Stu

Events

© 2014   Created by Roberto Navoni.

Badges  |  Report an Issue  |  Terms of Service