a Virtual Robotix Network Team

Hello everyone,
after some years of absence from the portfolio of the esc VR, I present the new design.
We made choices very conservative to have 27 and 50 amp ESC from 4s to 6s ... we are doing tests and validations necessary because this is a very delicate component.
Here are the first photos and video of the first test.
The firmware supported are the Simonk and BHely, given the complexity of the topic we did not want to reinvent the wheel but to make a quality product that can be certified and has the ability to be installed on a dedicated distribution board.

Attached are photos and here is the video

Views: 376


You need to be a member of FOXTEAM UAV CLAN to add comments!


Comment by gervais on September 28, 2014 at 12:23am

Looks nice, just one rec. DJI changed @ E300 ESC to two caps in order to achieve a more flat design. Never mind attaching LED, since they do it only @ Phantom ESC. Btw. its BLHeli, probably the best FW out.


© 2019   Created by Roberto Navoni.   Powered by

Badges  |  Report an Issue  |  Terms of Service