a Virtual Robotix Network Team

MiniQuad where i Plan to combine carbon tubes and 3d printed parts

I have been working on a new miniquad project where I did plan to use VRBrain controller, but now I must redesign it for the new VR Micro Brain :-)

I plan to use:
- 16mm carbon tubes (so I can mount ESC inside the tubes)
- 20A Slim Afro ESC
- SunnySky 2204s 2300Kv motors
- HQ Prop 6x3 Carbon Composit Props (some info on the motor/prop combo)
- VR Micro Brain :-)  + GPS + Telemetry radio
- Have Zippy Compact 1000, 1500 and 2200 3S that I plan to test

Here is some of my ideas so far:
Motor mount

One of my frame ideas:

A other frame testprint (43gr)

Views: 302


You need to be a member of FOXTEAM UAV CLAN to add comments!


Comment by Oyvind Amundsen on April 28, 2014 at 10:44pm

My first motor mount printed in white PLA with the SynnySky motor + 6" prop.

Comment by Oyvind Amundsen on April 27, 2014 at 4:42pm

Have designed a new motor mount for my mini quad project. This is going to help protecting the motor. I plan to print it using Taulman Bridge filament.


© 2019   Created by Roberto Navoni.   Powered by

Badges  |  Report an Issue  |  Terms of Service