FOXTEAM UAV CLAN

a Virtual Robotix Network Team

CTX4 V2 (parts arrived) + new project CX4M (mini)

While waiting on the CTX4 V2 CNC work to be done, I have started a new project CX4M  (a mini quad). I have finished the CX4M design. Next step is to get someone to do the CNC part (1,5mm carbone). The CTX4 V2 parts have arrived, so I can start working on that frame while waiting.

My CX4M setup:

Frame:                 25-26 cm motor – motor (1,5mm carbone)

Motors:               Turnigy Multistar 1900Kv

ESC:                      Afro 12A

Prop:                    5x4.5x3

Controller:          VRBRAIN (of course)       + Ublox lea 6 GPS

LiPo:                     Zippy Compact 1000mAh 35C 3S

Camera:              Mobius (HD recording + FPV)

FPV TX:                200mW 5,8Ghz

CTX4 V2 = C:Carbone T:Tube X:quad type 4:quad
CX4M = C:Carbone X:Quad type 4:Quad M:Mini

CTX4 V2 (right)
CX4M center plates (left) - The arm design was not ready when this CNC work was done.

Views: 167

Comment

You need to be a member of FOXTEAM UAV CLAN to add comments!

Join FOXTEAM UAV CLAN

Events

© 2019   Created by Roberto Navoni.   Powered by

Badges  |  Report an Issue  |  Terms of Service