FOXTEAM UAV CLAN

a Virtual Robotix Network Team

 

Have mounted a power board + 6 30mm alu standoffs + 4 tube clamps (from flyduino.net)
On the top center plate (at right) I have mounted 6 spacers with vibration damping.

 

ESC mounted to the side plates with the motor cables pointing to the ends of the side plates

 

The side plates mounted to the bottom plate – the ESC power cables will be soldered to the power board.

Views: 151

Comment

You need to be a member of FOXTEAM UAV CLAN to add comments!

Join FOXTEAM UAV CLAN

Comment by Oyvind Amundsen on September 28, 2013 at 2:42pm

I guess you refer to my new CX4M (mini) when you write small quad? CTX4 V2 is more normal size.

I`ll write about both – build log + my results,

I plan to use VRBrain in both of them.

Events

© 2019   Created by Roberto Navoni.   Powered by

Badges  |  Report an Issue  |  Terms of Service